Hello Nikos,
As Mike described before a little script was added to the install progress, which enables all existing users to use x2goserver. This was added because there where a lot of complaints about the installation procedure.
You won't need to use a graphical tool to remove users. This can be done by command line or you open the file /etc/group in your favourite editor and remove any unwanted users from that group (you should be careful of cause).
best regards,
Heinz
Am 20.11.2010 01:04, schrieb Nikos Chantziaras:
I followed the instructions in the Wiki and installed x2goserver-one on my Debian Lenny server. However, during the installation, it told me:
Attention: If you want to allow users to log into the x2go system, you'll need to add them to the "x2gousers" group
but then it went on all on its own and added all users (about 300) of the system to the "x2gousers" as well as "fuse" groups! How do I undo that? Right now, I need to click around for hours in the Users and Groups admin tool :-$
X2go-dev mailing list X2go-dev@lists.berlios.de https://lists.berlios.de/mailman/listinfo/x2go-dev