A page in your DokuWiki was added or changed. Here are the details: Date : 2017/01/02 02:47 Browser : Mozilla/5.0 (Windows NT 6.1; WOW64; rv:45.0) Gecko/20100101 Firefox/45.0 IP-Address : 78.43.90.159 Hostname : HSI-KBW-078-043-090-159.hsi4.kabel-badenwuerttemberg.de Old Revision: http://wiki.x2go.org/doku.php/doc:howto:tce?rev=1483324632 New Revision: http://wiki.x2go.org/doku.php/doc:howto:tce Edit Summary: [List of open ToDos/FIXMEs for this page] User : stefanbaur @@ -398,8 +398,15 @@ Also, when using iso-hybrid and USB media, there are a few "cheats" to reclaim unused space on the USB media, and to turn it into a solution that allows you to run X2GoClient in portable mode on Windows, and boot it as X2Go-TCE, with a shared configuration file. FIXME Document how to add second partition to USB media after dd'ing the iso-hybrid image, and how to add X2GoClient-Portable to it. + + * The catch is that on USB media, Windows will only see the partition with the partition number 1, even if there is more than 1 partition. + * However, it doesn't care whether the partition bearing the number 1 is actually the first partition. It will happily display the contents of the second partition as long as it bears the number 1. + * So, one has to change the partition number of the dd'ed image to 2, then create a new partition in the remaining space and assign it the number 1 and a partition type of FAT (NTFS *might* work, but is untested.) + * After that, partition "number 1" - actually the second partition on the USB media - can be formatted. + * Once formatted, one can install X2GoClient for Windows on it, and add a short batch script or similar to run it in portable mode (''x2goclient.exe --portable --session-conf=sessions''). + * Stefan has written a script to automate this as good as possible, but it is still too fragile to release (fixed paths, many assumptions, no error checking = potential for serious breakage including data loss). FIXME This page is missing a section/subpage that explains how to create images for local storage. Basically, proceed as shown for netboot above, but set LBX2GO_IMAGETYPE to iso or iso-hybrid (recommended). Do not select hdd or tar - even though it is supposed to becoma a local storage installation. -- This mail was generated by DokuWiki at http://wiki.x2go.org/