[X2Go-User] login window only

[Stefan Baur]

Am 25.06.2018 um 20:17 schrieb alaxa at libero.it:
> I'm sorry, i admit I wasn't clear enough.
> so, basically we have 30 little windows pc that act as thinclient. At the welcome screen there are the options to use "windows" or "linux" and each with a specific configration set, call it "session". So when I press "Linux" it calls the MYSESSION only with its settings.
> Now, I wanted to keep this welcome interface as clean and easy possible. The good was pyHoca-gui with its "username/password" window, but again, it's too slow to start once a user press "Linux"
> 
> then I saw that x2goclient can accept many parameters if run by command line and infact it works nice with the ones I specified in the previous message. Only the GUI is not "clean": it's split vertically in two parts and "worst", on the right, one can still see the name of the session. Well, it's not a drama, but it's not so clean as the pyHoca interface.

You could also use --close-disconnect, that way X2GoClient terminates
after disconnecting, rather than placing you in the session tiles view.

Kind Regards,
Stefan Baur

-- 
BAUR-ITCS UG (haftungsbeschränkt)
Geschäftsführer: Stefan Baur
Eichenäckerweg 10, 89081 Ulm | Registergericht Ulm, HRB 724364
Fon/Fax 0731 40 34 66-36/-35 | USt-IdNr.: DE268653243