[X2Go-User] Switching workspaces
blake1024 at gmail.com
Wed Jan 3 05:17:52 CET 2018
The setup has been working perfectly for me for years. However, one
monitor is higher than the other so I have a verticle offset set so that
the pointer moves cleanly horizontally without a vertical jump. Also, the
two monitors are not the same size. (as you've probably seen from the
Thank for looking into this!!
On Tue, Jan 2, 2018 at 7:20 PM, Ulrich Sibiller <uli42 at gmx.de> wrote:
> On Tue, Jan 2, 2018 at 11:41 PM, Blake McBride <blake1024 at gmail.com>
> > Thanks!!
> > $ xrandr
> > Screen 0: minimum 320 x 200, current 3840 x 1847, maximum 8192 x 8192
> > LVDS-1 connected 1920x1080+0+767 (normal left inverted right x axis y
> > 360mm x 200mm
> > 1920x1080 59.9*+ 60.0 50.0
> > VGA-1 disconnected (normal left inverted right x axis y axis)
> > HDMI-1 connected 1920x1200+1920+0 (normal left inverted right x axis y
> > 518mm x 324mm
> > 1920x1200 60.0*+
> So your left display is - for reasons I don't know - vertically
> shifted by 767 pixels. In other words: it does not start at the same y
> position as your second one but 767 pixels below.
> > $ xdpyinfo -ext XINERAMA> XINERAMA version 1.1 opcode: 141
> > head #0: 1920x1080 @ 0,767
> > head #1: 1920x1200 @ 1920,0
> Xinerama is showing exactly the same as xrandr: a vertical shift of
> your left display by 767 pixels. So you need to find out why. Are you
> really using that setup without problems (apart from nx/x2go)?
> If that setup is intended by you then please report the output of the
> two commands from inside the session.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the x2go-user